Win-Test Reference Manual : Messages variables

Messages variables

Variables are always uppercased and prefixed with $.

$REPEAT : Resets the timer of the automatic CQ repeat mode, if enabled
$CR : Nothing is sent, but keys Return in the log
$F1 to $F7 : Will send message n°1 for $F1, n°2 for $F2 etc ...
Be careful : do not generate a loop !

$MYCALL : Yorr callsign
$LOGGEDCALL or $LOGGED: Captured callsign
$RST : Report sent
$SERIAL : Serial number
$GRIDSQUARE or $LOCATOR : Yorr gridsquare
$ZONE or $DPT or $STATE or $OBLAST or $PROVINCE : Your zone number (etc ...) captured while parametering the contest
$POWER or $PWR : Your power, captured while parametering the contest
$QSOB4 : Will send "QSO B4" (QSO before) and stop the message if the callsign captured is a dupe, otherwise nothing
$CORRECT: Will send the captured callsign if it has changed since the last time the $LOGGEDCALL variable has been used, otherwise nothing

You can also use the + and - keys to increase or decrease the CW speed inside a standard message. The + and - must be balanced inside a message.

$RESET : Will reset the headphone status it was before the start of this message. Equivalent to the Operating / Revert to automatic control command.

Last update : 2005 april 28